ATA8741-PXQW【PDF 91/238 页】MCU W/TRANSMITTER ASK/FSK 24QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录52

87页 88页 89页 90页 [91页]92页 93页 94页 95页

9140CINDCO02/10

ATA8741

Signal description (internal signals):

count

Increment or decrement TCNT0 by 1.

direction

Select between increment and decrement.

clear

Clear TCNT0 (set all bits to zero).

clk

Timer/Counter clock, referred to as clk

in the following.

top

Signalize that TCNT0 has reached maximum value.

bottom

Signalize that TCNT0 has reached minimum value (zero).

Depending of the mode of operation used, the counter is cleared, incremented, or decremented

at each timer clock (clk

). clk

can be generated from an external or internal clock source,

selected by the Clock Select bits (CS02:0). When no clock source is selected (CS02:0 = 0) the

timer is stopped. However, the TCNT0 value can be accessed by the CPU, regardless of

whether clk

is present or not. A CPU write overrides (has priority over) all counter clear or

count operations.

The counting sequence is determined by the setting of the WGM01 and WGM00 bits located in

the Timer/Counter Control Register (TCCR0A) and the WGM02 bit located in the Timer/Counter

Control Register B (TCCR0B). There are close connections between how the counter behaves

(counts) and how waveforms are generated on the Output Compare output OC0A. For more

details about advanced counting sequences and waveform generation, see Modes of Opera-

tion on page 94.

The Timer/Counter Overflow Flag (TOV0) is set according to the mode of operation selected by

the WGM01:0 bits. TOV0 can be used for generating a CPU interrupt.

20.5 Output Compare Unit

The 8-bit comparator continuously compares TCNT0 with the Output Compare Registers

(OCR0A and OCR0B). Whenever TCNT0 equals OCR0A or OCR0B, the comparator signals a

match. A match will set the Output Compare Flag (OCF0A or OCF0B) at the next timer clock

cycle. If the corresponding interrupt is enabled, the Output Compare Flag generates an Output

Compare interrupt. The Output Compare Flag is automatically cleared when the interrupt is exe-

cuted. Alternatively, the flag can be cleared by software by writing a logical one to its I/O bit

location. The Waveform Generator uses the match signal to generate an output according to

operating mode set by the WGM02:0 bits and Compare Output mode (COM0x1:0) bits. The max

and bottom signals are used by the Waveform Generator for handling the special cases of the

extreme values in some modes of operation. See Modes of Operation on page 94.

Figure 20-3 on page 92 shows a block diagram of the Output Compare unit.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式